Electronic symbol

Revision as of 22:32, 13 June 2024 by Rob Kam (talk | contribs)

Electronic symbols are graphical representations used to depict electronic components, devices, and circuits in circuit diagrams and schematics. These symbols help engineers, technicians, and hobbyists communicate and understand the design and functionality of electronic circuits. Electronic symbols should be intuitive, allowing users to grasp their meaning at a glance.

Examples of electronic symbols

These symbols are standardized, and various organizations, such as the International Electrotechnical Commission (IEC) and the Institute of Electrical and Electronics Engineers (IEEE), provide guidelines for their use. It's essential to understand these symbols when reading or creating circuit diagrams to design and troubleshoot electronic circuits. The following is a selection of some of the most common symbols.

Component Reference designator Unit Symbol
Resistor, IEEE and IEC style R Ohm    
Potentiometer, IEEE and IEC style RV Ohm    
Trimmer resistor, IEC style RT Ohm
 
Capacitor C Farad
 
Polarised capacitor C Farad
 
Variable capacitor CV Farad
 
Trimmer capacitor CT Farad
 
Inductor L Henry
 
Magnetic core inductor L Henry
 
Transformer with two secondary windings T  — 
 
Quartz crystal Y or XTAL Herz
 
Diode D  — 
 
 
Schottky diode D with number  — 
 
 
Zener diode ZD  — 
 
 
Varactor diode VD or D with number  — 
 
 
LED LED  — 
 
 
NPN bipolar junction transistor Q  — 
 
 
PNP bipolar junction transistor Q  — 
 
 
N-channel JFET Q  — 
 
P-channel JFET Q  — 
 
Operational Amplifier U with part number  — 
 
Microphone, IEEE and IEC style MIC Ohm
 
 
Loudspeaker SPKR Ohm
 
Single cell and battery B or BAT Volt
 
 
Incandescent light bulb FIL Watt
 
Voltmeter and ammeter V and A
 
 
Push-to-make switch, push-to break switch, IEEE style SW with description  — 
 
 
SPST and SPDT switch SW with description  — 
 
 
DPST and DPDT switch SW with description  — 
 
 
DPST and DPDT relay K with description  — 
 
 
TS and TRS jack socket TS and TRS  — 
 
 
DC barrel connector, positive tip J  — 
 
Voltage source and current source V and I  — 
 
 
Fuse, IEEE and IEC style F Amp
 
 
Antenna A  — 
 
Earth GND or EARTH  — 
 
Chassis ground GND or CHASSIS  — 
 
Wires crossing and junction  —   — 
 
 

External links

⮜ Previous: Units of measurement Next: Schematics